Human Health and Performance Environmental Chamber

Human Health and Performance Environmental Chamber
Human Health and Performance Environmental Chamber
We have the capabilities to work on highly demanding and customized projects. We pride ourselves with the highest quality US made products. When our customers contact us, we provide them with a complete, ready to go out of the box solution. No additional design, development, engineering, assembly, or other tedious actions are needed because our products are developed, designed, built, and shipped to you. We do the complex, detailed, and heavy lifting so that you don’t have to. We know that you have other priority tasks to complete and building a performance chamber should be our job because we are damn good at it. When you work with us, it is as if you have another engineering team of highly skilled and technical people who are ready to tackle any challenge you may face. Our machinists are engineers, our engineers are subject matter experts, and our subject matter experts are your project partners capable of tackling highly demanding and critical projects.

Our wonderful, many times repeat customer reached out to us for another Performance Environmental chamber they wanted us to make for them. The internal dimensions are 12 inch cube. They also needed two USB feedthrough ports installed on the front wall and one NW25 blanked off port installed on the right wall. This chamber is capable of full vacuum and pressures up to 15PSIG. Anything beyond 15 psig of overpressure and the pressure relief valve, which is installed on the lid, will pop open and vent the overpressure bringing it down to 15 psig again. This is a safety measure in order to prevent over-pressurization of chamber. The chamber also has two lid handles to allow for fully removable lid. As a standard, the chamber also has a dial pressure and vacuum gauge as well as two NPT valve. The lid is clamped down via QTY: 8 x thumb clamps.

Looking for a pressure or vacuum chamber? Need a highly skilled and knowledgeable manufacturer? Do you prefer someone who takes pride and their work and truly cares about the quality of everything that ships out of their shop? Contact us.

Similar Items

Our clients prefer to work with us because we are Experts in Custom Fabrication (especially Polymer Fabrication). Check out some of our other items we carry that you can combine/integrate with your systems or projects.

Pressure Decay Leak Testing Systems
Pressure Decay Leak Testing Systems are instruments that detect and quantify a leak by measuring the pressure drop over specified amount of time. Any specimen that is inflated will stay inflated if it is leak tight. On the other hand, of a leak exists in the inflated specimen, air will escape through the orifice and decrease the pressure inside the specimen. The higher the pressure drop, the high the leak.
Ethernet Vacuum Feedthroughs
Ethernet Vacuum Feedthroughs are Vacuum Rated Ethernet connectors that enable you to run ethernet cables into your vacuum chamber. Simply connect your ethernet connector to the outside of the vacuum chamber and another ethernet cord from the inside and run it into your part present inside your vacuum chamber.
Our Work: Pressure and Vacuum Chamber used for Calibration of Weather Stations across the US
Have you ever wondered how the weather forecast works? You must admit; the weathermen (or weatherwoman) have become a whole lot more accurate over time. 10 years ago, the weather forecast was not as accurate as it is today. Part of the reason is that we have better forecasting technology as in more powerful computers who crunch numbers faster to out a most likely scenario. Another reason is that mathematics, physics, and science has progressed. The main reason however, is that we have better tools and equipment.
Related Articles: Clear Acrylic Vac Chamber Review
In this article we take a closer look into acrylic vacuum chambers, what they are used for, the advantages of using a clear acrylic vac chamber, what to look for, and where to purchase one.